If Your Fabricsmart™ Beeps For Help - Fisher & Paykel FabricSmart Installation Instructions And User Manual

If your FabricSmart™ beeps for help
30
Before you call for service
Please read the following pages before calling for service.
You can correct many of your machine's problems using the checklists on the following pages.
Your machine is capable of diagnosing its own problems and if it has a problem it will beep and
display a message telling you what is wrong.
Musical series of beeps* every 5 seconds and... possible solutions
* The same sound your washer makes when you turn it on at the wall.
"My load is OUT OF BALANCE"
Wash load is out of balance.
Ensure the machine is stationary and manually redistribute the load.
Check machine is level (see Installations Instructions, page 3).
"I am not getting any HOT WATER"
Hot water supply is not hot enough to maintain the wash temperature you have selected.
Select a lower wash temperature.
Inlet hose screens may be blocked.
There may be a kink in the hose (refer to page 3).
Hot tap has not been turned on.
Inlet hoses connected to the wrong taps.
The flow rate of the supply water is too slow.
"I am not getting any COLD WATER"
Cold tap has not been turned on.
Inlet hose screens may be blocked.
There may be a kink in the hose (refer to page 3).
Inlet hoses connected to the wrong taps.
Cold water temperature exceeds recommended limits (refer to page 4).
The flow rate of the supply water is too slow.