Table of Contents
Advertisement
22. Check that the plow blade is level on the
ground with the wings in the scoop position
and the plow on the ground.
Level the plow by first loosening the jam nut
on the stop bolt at the back of the center
mast, then turning the bolt in or out to adjust
the plow ends. Retighten the jam nut once
the plow is level with the ground. Grease
the fitting to prevent future corrosion.
23. Fasten the power unit cover assembly onto
the lift frame bracket with two 1/4 inch x 3/4
inch carriage bolts, flat washers and lock
nuts from the hardware bag in the parts box.
Tighten the lock nuts so that the assembly
is secure, yet the cover hinges freely.
Snip the plastic tie strap inside the cover as-
sembly to release the two cover latch han-
dles. When the cover is closed, rods from
the latch handles should extend behind the
light brackets to hold the cover in place.
24. Assemble side markers on the ends of the
DWG NO. 3847
DWG NO. 5843
moldboard with 5/16 inch bolts, flat washers
and lock nuts.
V-Plow Assembly 21
DWG NO. 5854
Advertisement
Table of Contents
