Hiniker 1852 Operator's Manual page 17

Use a plastic tie strap to band the four wing
cylinder hoses together at the approximate
dimensions shown. Also band the hoses to-
gether just ahead of the hose loop and as
they hang vertically behind the loop. Pull slack
hose behind the loop.
6. Before assembling the headlamp brackets on
the lift frame tube, scrape a small amount of
paint from the three holes in each bracket and
the four holes in the frame tube to provide a
good electrical ground for the turn signals and
parking lights.
Mount the headlamp brackets to the lift frame
tube with four 3/8 inch x 2 inch carriage bolts
and flanged lock nuts from the hardware bag
in the parts box.
Remove the LH and RH headlamps from their
boxes and mount on the brackets with hard-
ware from the headlamp boxes.
Use plastic tie straps to band headlamp ca-
bles above and below the brackets at the
locations shown to provide clearance for the
power unit cover rods later.
7. Identify the power cable assembly and wiring
harness for the plow power unit in the electri-
cal components parts box. A ground harness
for solenoids on the power unit is in the power
unit box.
The power cable assembly has two cables
with ring terminals on one end and a two pin
connector on the other, and measures about
38 inches long.
The wiring harness has a ten pin connector
and a three pin connector on one end and the
other end has connectors labeled "DRIVER
DWG NO. 5842
SIDE" and "PSNGR SIDE" for the headlamps,
and six loose wires with spade receptacles
and one wire with a ring terminal.
The ground wire harness has a ring terminal
and six spade receptacles on two wires.
Refer to drawing 5849. Attach the ring termi-
nal of the solid red (or red striped) wire of the
power cable assembly to the terminal on the
motor at location 1.
Fasten the ring terminal of the solid black wire
of the power cable assembly, the black wire
with the ring terminal on the plow harness, and
the ring terminal of the ground wire harness to
the terminal on the motor at location 2.
Attach the coil ground wire harness as
shown.
Band the plow wiring harness to the lift frame
tube with a plastic tie strap, as indicated in
drawing 5853 at location 3. Refer to the draw-
ings for routing wires to the power unit and
headlamps.
V-Plow Assembly 15
DWG NO. 5849
DWG NO. 5853