Hiniker 1852 Operator's Manual page 22

20 V-Plow Assembly
20. At this point, assemble the mount kit on the
truck as described in the instructions supplied
with each kit.
Prongs from the truck mount kit should be at
a height that will slightly lift the plow frame
when attaching the plow.
Apply powdered graphite on the prongs to
help the plow slide on and off more easily.
Prong receivers on the plow frame must be
parallel to the ground before attaching the
plow.
Attach the plow onto the truck by driving the
truck prongs into the receivers on the plow
frame. Pull the latch handle into the frame
clevis to move sliders through the notches in
the prongs and receivers. Pin the handle in
the clevis with its klik pin.
Raise the parking stand to its highest position
and repin.
Connect the three electrical cables from the
plow to their corresponding receptacles on
the truck.
21. Select an appropriate hydraulic oil from the
DWG NO. 4166
NOTE: A new hydraulic lift cylinder may leak a
small amount of oil until packings become sat-
urated and produce a good seal. If leakage is
excessive, or if leaking continues after initial cy-
cling, tighten the cylinder packing nut in 1/8-turn
increments until leaking stops.
DWG NO. 5232
accompanying chart.
Pour hydraulic oil into the power unit reservoir
until the oil level reaches the fill level.
Raise and lower the plow, and cycle the
wings to purge any air trapped in the sys-
tem. Check the oil level with the plow on
the ground and the wings retracted.
Add oil to the fill line, if necessary, but do
not overfill the reservoir.
DWG NO. 3066
DWG NO. 5847