Hiniker 1852 Operator's Manual page 18

16 V-Plow Assembly
Connect the Tan wire of the wiring harness
to the spade terminal on solenoid S1.
Connect the Pink wire to solenoid S2.
Connect the Gray wire to solenoid S3.
Connect the Brown wire to solenoid S4.
Connect the Blue with White stripe wire to
solenoid S5.
Connect the Blue wire to solenoid S6.
Connect the RH headlamp to the har-
ness end labeled "PSNGR SIDE" and the
LH headlamp to the end labeled "DRIVER
SIDE".
WARNING: Disconnect truck battery
before beginning electrical installa-
tion to avoid shock hazard.
The pump solenoid, underhood wiring harness,
power cable and joystick control box are locat-
ed in the parts box shipped with the snowplow
frame.
NOTE: Fill electrical connectors with dielectric
grease, and lightly coat ring and spade termi-
nals before installation to prevent corrosion.
8. Refer to drawing 3907. To begin underhood
wiring installation, lay the harness in it's ap-
proximate position for final assembly. Posi-
tion the 7-pin and 3-pin circular connectors
near the drivers side firewall, the 10-pin
and 3-pin connectors just left of center near
9.
DWG NO. 5844
10. If there is no access hole in the drivers side
11. Select an area near the drivers side fender
12. Splice the red with white stripe wire to the
13. Connect the joystick control box to the 7-pin
the grill, the relays near the drivers side in-
ner fender and the 5-pin headlight connec-
tors at the respective headlights.
Determine the location of the vehicle bat-
tery. If the battery is located on the right
(passenger) side or if there are two batter-
ies configured as a 12 volt system then pro-
ceed to step 10. If the battery is located on
the left side of the vehicle then the wiring
harness will need to be modified.
Refer to drawing 3908. Remove the tape
from the Black corrugated loom at the
points shown. Locate an Orange, Red, and
two Black wires. These wires connect to the
battery and pump solenoid. Remove the
four wires from approximately 33 inches of
the loom, making sure the Red and Black
wires are long enough to connect to the bat-
tery. Tuck these wires back into the loom as
shown in the drawing and retape the loom.
firewall then drill a 1-1/8 inch diameter hole.
Route the 7-pin and 3-pin circular connec-
tors through the firewall into the cab com-
partment and install the 4 inch grommet in
the hole, if required.
CAUTION: Ensure that the relays will
clear any hood lift/spring mechanisms
before installation.
for the relays. Drill three 1/8 inch diameter
holes and secure the relays with #8 X 1/2
inch self-tapping screws from the hardware
bag in the parts box.
vehicle's switched 12 volt auxiliary electri-
cal circuit. This will prevent operation of the
plow without the vehicle key being on. This
wire controls the accessory relay that pow-
ers the control joystick and solenoids.
and 3-pin connectors inside the truck cab.
Secure the box at a safe location in the cab
with the strip of hook and loop fastener.