Hiniker 1852 Operator's Manual page 16

14 V-Plow Assembly
Mount the power unit on the lift frame with
two 3/8 inch x 3/4 inch hex bolts and two
3/8 inch lock washers. The plastic reservoir
of the power unit should be to the left side
of the plow (see following illustration).
Remove shipping straps from the wing cylin-
ders by snipping the plastic ties and unpinning
the rod-end clevis pins. Discard the straps, then
reassemble the cylinder rods between lugs with
clevis pins and cotter pins.
Locate the nine remaining O-ring/flare hydraulic
adapters in the hardware bag: four straight adapt-
ers and five 90 adapters. Turn the O-ring end of
o
the four straight adapters into ports marked A, B,
C and D on the power unit. Turn the O-ring end
of a 90 adapter into port E on the power unit and
o
direct the flare end down and toward the motor
end (see drawing 5840).
Turn the O-ring end of the four remaining 90
adapters into ports on the wing cylinders. Direct
flared ends of the adapters toward one another
on each cylinder, with the rod end adapters ro-
tated rearward about 20
terline.
DWG NO. 5839
o
from the cylinder cen-
o
DWG NO. 5840
Assemble the short hydraulic hose from the parts
box between the lift cylinder and port E on the
power unit. Route the hose over the top of the lift
cylinder.
Route three of the remaining four hydraulic hoses
through the loop on the push frame and over the
two RH trip springs such that the straight hose
ends will assemble to the wing cylinders and the
90 o ends will assemble the power unit. Lay the
fourth hose along the previous three, only outside
the loop.
Connect port A on the power unit to the rod end
of the RH wing cylinder, using one of the hoses
through the loop.
Connect port B on the power unit to the butt end
of the RH wing cylinder, using one of the hoses
through the loop.
Connect port C on the power unit to the rod end of
the LH wing cylinder, using the hose laid outside
of the loop. Route the hose ahead of the lift frame
tube.
Connect port D on the power unit to the butt end of
the LH cylinder, using the remaining hose through
the loop. Route the hose ahead of the lift frame
tube.
DWG NO. 5841
DWG NO. 5845