Hiniker 1852 Operator's Manual page 20

18 V-Plow Assembly
WARNING: Ensure that the pump so-
lenoid and associated wiring will clear
any hood lift/spring mechanisms be-
fore installation.
14. Select an area within 16 inches of the ve-
hicle battery for the pump solenoid. Drill
two 3/16 inch diameter holes and fasten the
solenoid with two 1/4 inch X 1/2 inch long
self tapping screws from the hardware bag
in the parts box. Connect the Black wire to
one of the small posts on the solenoid, con-
nect the Orange wire to the remaining small
post, polarity is not important.
15. Safely route the 10-pin and 3-pin circular
connectors through the grill of the vehicle
to a location that will be easily accessible
with the plow attached.
16. Refer to drawing 3891. Install the under-
hood power cable by first connecting the
ring terminal from the solid Black cable and
the two Black wires from the harness to the
minus (-) post of the vehicle's battery. Con-
nect the ring terminal from the solid Red (or
Red striped) cable to the pump solenoid ter-
minal, route the power cable to the grill near
the 10-pin connector.
Install the 24 inch Red power cable between
the pump solenoid and the vehicle's starter
solenoid positive terminal. If the vehicle's
starter solenoid is not accessible, con-
nect the Red (or Red striped) cable to the
plus (+) terminal of the battery. Connect the
Red fused wire to the positive terminal of
the battery.
17. Remove the plug mount plate kit from the
hardware bag in the parts box.
Refer to drawing 5295.
Fasten the power cable connector to the
clamp by inserting the #6 X 1 inch ma-
chine screw through the small hole in the
connector, then through the center hole of
the clamp. Secure the screw with a #6 lock
nut.
Fasten the clamp to the mount plate with
the two #10 X 1-1/2 inch machine screws
and #10 lock nuts supplied.
Mount the 10-pin circular connector to the
mount plate with four #6 X 1/2 inch screws
and lock nuts such that the tab on the con-
nector will be up, as shown.
Mount the 3-pin circular connector to the
mount plate with four #6 X 1/2 inch screws
and lock nuts such that the tab on the con-
nector will be up, as shown.
Assemble the mount plate and connector
covers to the vehicle grill with plastic ties.
DWG NO. 3891