Operation - PROEL PLLED110 User Manual

OPERATION

After you connected the effect to the mains, the fixture starts running. During the reset, the motors are
trimmed and the device is ready for use afterwards.
Each projector occupies 6 or 15 DMX channels. To ensure that the control signals are properly directed
to each projector, the projector requires addressing. This is to be done for every single projector by
display as following described.
Please make sure that you don't have any overlapping channels in order to control each projector
correctly and independently from any other fixture on the DMX data link. If two, three or more projector
is addressed similarly, they will work similarly.
After having addressed all projectors, you may now start operating these via your lighting controller.
NOTE:
After switching on, the projector will automatically detect whether DMX 512 data is received or not. If
there is no data received at the DMX-input, this situation can occur if:
the 3 PIN XLR plug is not connected with the input of the projector
-
the controller is switched off or defective
-
the cable or connector is defective
-
the signal wires are swap in the input connector
-
WORKING MODE
1. Control with foot switch:
In any mode it is possible to use foot switch controller.
The functions of this foot controller are:
BLACK OUT: to turn off the projectors
FREEZE: to lock the current condition
SOUND-ACTIVE: to activate sound control mode
PRESET: to select preset programs
It is possible to turn off the foot switch controller by pressing BLACK OUT + SOUND ACTIVE.
2. Static color mode:
Press MODE button, press SET-UP. When on the display it will appear "CL.-X" it is possible to select
between 8 static colours (from 0 to 7). When on the display it will appear "FS.XX" it is possible to select
flash speed (from 0 to 99).
3. Manual mode:
Press MODE button, press SET-UP. When on the display it will appear "r.XXX", "G.XXX" e "b.XXX", press
UP / DOWN buttons to select the intensity of Red, Green and Blue. When on the display it will appear
"FS.XX" it is possible to select flash speed (from 0 to 99).
4. Auto mode:
Press MODE button, press SET-UP. When on the display it will appear "Pr.XX", press UP / DOWN buttons
to select between one of 11 built-in programs. When on the display it will appear "SP.XX" it is possible to
select run speed (from 0 to 99). When on the display it will appear "FS.XX" it is possible to select flash
speed (from 0 to 99).
5. Auto run mode:
Press MODE button. When on the display it will appear "AUTO", the built-in programs run one after
another in loop. When on the display it will appear "SP.XX" it is possible to select run speed (from 0 to
99). When on the display it will appear "FS.XX" it is possible to select flash speed (from 0 to 99).
13