Completing The Fru Replacement - IBM 2292 Hardware Maintenance Manual

5. Push in on the two tabs to rotate the hard disk drive outward.
6. Push in on the rail guides and slide the hard disk drive out.
7. Reverse this procedure to install the new hard disk drive.
8. Go to "Completing the FRU replacement." when the system board has been

Completing the FRU replacement.

After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the FRU that is replaced, you might need to confirm the updated information in
the IBM Setup Utility program.
Note: When the power cord is first plugged in, the computer might appear to turn
on for a few seconds and then turn off. This is a normal sequence to enable the
computer to initialize.
1. Ensure that all components have been reassembled correctly and that no tools
2. Make sure the cables are correctly routed and are retained by the cable clips.
3. Close or replace the cover.
4. If your computer is being placed in the vertical position, attach the floor stand.
5. Reconnect the external cables and power cords to the computer.
6. If you are replacing the system board, you must update (flash) the BIOS. See
7. Some FRU replacements rquire the configuration to be updated. See "Setup
8.
Note: Make sure you obtain the proper Recovery CD to use after installing the
hard disk drive.
installed.
or loose screws are left inside your computer.
Attention: To prevent overheating and possible component damage, always
attach the floor stand when placing the computer in the vertical position.
"Flash update procedures" on page 181.
Utility program" on page 14.
Chapter 6. Replacing FRUs
45