IBM 2292 Hardware Maintenance Manual page 10

DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to 002 .
If YES, proceed to 003 .
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program. See "Setup Utility program" on
2. Select Power Management from the Configuration/Setup Utility program
3. Select APM.
4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (}) or
5. Select Automatic Hardware Power Management.
6. Set Automatic Hardware Power Management to Disabled.
7. If the problem persists, continue to 003 .
Run the Diagnostic programs. If necessary, refer to "Diagnostics" on page 16.
v If you receive an error, replace the part that the diagnostic program calls out or
v If the test stops and you cannot continue, replace the last device tested.
4
Hardware Maintenance Manual Types 2292, 2273, 6043, 6343, 6349, 6350, 6790, 6791, 6792, 6793, 6794, 6795, 6823, 6825
002
page 14.
menu.
Right Arrow (Æ) to change the setting.
003
go to "Symptom-to-FRU Index" on page Chapter 7, "Symptom-to-FRU index,"
on page 47.