Removing The Front Bezel; Moving The Power Supply - IBM 2292 Hardware Maintenance Manual

5. Lift the fan out of the chassis.
6. Reverse this procedure to install the new fan.
7. Go to "Completing the FRU replacement." on page 45 when the fan has been
installed.

Removing the front bezel

1. Shut down your operating system and turn off the computer.
2. Remove the cover. See "Removing the cover" on page 39.
3. Push in on the blue bezel release arm at the rear of the chassis to disengage the
front bezel from the chassis.
4. Lift the bezel off the front of the computer.

Moving the power supply

To perform some operations inside the computer, you might need to move the
power supply to access parts of the system board that are difficult to see or hard to
reach. Use the following procedure to provide easier access to the system board.
1. Locate the power supply. See "Locating components" on page 38.
Chapter 6. Replacing FRUs
41