Table of Contents
Advertisement
MultiPASS MP730/MP700 Chapter 3: Assembly and Disassembly
1.4 All Clear (Action in the Event of Abnormality)
In the event of extreme noise or shock, etc., in very rare cases, the display may go out, and all the
keys become inoperable. In that case, perform an All Clear. This operation returns all values and
settings to their default settings. However, as all settings, such as received images and user data,
service data, etc., will be re-initialised, be sure to note down any settings that you will need to re-
enter later.
After you have executed 'all clear', set the type setting (country setting).
Menu
Select ALL
Menu
Select U.S.A.
Stop/Reset
1.5 Shipping the Main Unit
If you must ship the machine as after making repairs, be sure to go through the following:
(1) See to it that the BJ cartridge (printhead) remains fitted in the carriage.
(2) Press the On/Off key to turn off the power, and fix the carriage in its home position;
then, disconnect the power cord.
If you leave the BJ cartridge (printhead) alone on its own, the ink can start to
cake. Be sure to keep the BJ cartridge fitted in the carriage in the course of
shipment.
On the other hand, if the carriage is not fixed to its home position, it can move
right/left during shipment, possibly imposing stress on the paper feed encoder
film. Check to make sure it is fixed in its home position.
Copy
#
Select #8 CLEAR
#8 CLEAR
ALL
Copy
#
Select #5 TYPE
#5 TYPE
U.S.A.
Standby
Figure 3-4 All Clear Operation
SERVICE MODE
#8 CLEAR
Set
Execute All clear
SERVICE MODE
#5 TYPE
Set
Setting the country type
3-8
Set
Standby
Set
Advertisement
Table of Contents
