Canon MP 700 Service Manual page 86

MultiPASS MP730/MP700 Chapter 4: Maintenance and Service
No. Tx or Rx
##670 [TX]
##671 [RX]
##672 [TX]
##673 [RX]
##674 [TX]
##675 [RX]
##750 [TX]
##752 [TX]
##753 [TX]
##754 [TX]
##755 [TX]
##757 [TX]
##758 [TX]
##759 [TX]
##760 [TX]
##765 [TX]
##767 [TX]
Definition
In V.8 late start, the V.8 ability was detected in DIS from the
other party and, in response, CI was transmitted; however, the
procedure failed to advance, causing a T1 time-over condition
In V.8 call arrives, the procedure fails to advance to phase 2 after
CM detection, causing a T1 time-over condition
In V.34 transmission, the procedure fails to move from phase 2
to phase 3 and later, causing a T1 time-over condition
In V.34 reception, the procedure fails to move from phase 2 to
phase 3 and later, causing a T1 time-over condition
In V.34 transmission, the procedure fails to move from phase 3
or phase 4 to a control channel or later, causing a T1 time-over
condition
In V.34 reception, the procedure fails to move from phase 3 or
phase 4 to a control channel or later, causing a T1 time-over
condition
In ECM transmission, no significant signal can be received after
transmission of PPS-NULL, and the allowed number of
procedure signal re-transmissions was exceeded
In ECM transmission, DCN was received after transmission of
PPS-NULL
In ECM transmission, the allowed number of procedure signal
re-transmissions was exceeded or a T5 time-over (60 sec)
condition occurred after transmission of PPS-NULL
In ECM transmission, the allowed number of procedure signal
re-transmissions was exceeded after transmission of PPS-NULL
In ECM transmission, no significant signal can be received after
transmission of PPS-MPS, and the allowed number of procedure
signal re-transmissions was exceeded
In ECM transmission, DCN was received after transmission of
PPS-MPS
In ECM transmission, the allowed number of procedure signal
re-transmissions was exceeded or a T5 time-over (60 sec)
condition occurred after transmission of PPS-MPS
In ECM transmission, the allowed number of procedure signal
re-transmissions was exceeded after transmission of PPS-MPS
In ECM transmission, no significant signal can be received after
transmission of PPS-EOM, and the allowed number of
procedure signal re-transmissions was exceeded
In ECM transmission, no significant signal can be received after
transmission of PPS-EOP, and the allowed number of procedure
signal re-transmissions was exceeded
In ECM transmission, DCN was received after transmission of
PPS-EOP
4-21