Canon MP 700 Service Manual page 84

c) ERROR CODE LIST
The error codes that have newly been added starting with the product are identified by the
notation "new" those error codes for which remedies unique to the product are offered are
identified by the notation "UNQ (UNIQUE)."
c-1) User error code
No. Tx or Rx
#001 [TX]
#003 [TX/RX]
#005 [TX/RX]
#006 [TX]
[RX]
#008 [TX]
#009 [RX]
#011 [RX]
#012 [TX]
#018 [TX/RX]
#021 [RX]
#022 [TX]
#037 [RX]
#052 [RX]
#085 [TX]
UNQ
#995 [TX/RX]
c-2) Service error code
No. Tx or Rx
##100 [TX]
##101 [TX/RX]
##102 [TX]
##103 [RX]
##104 [TX]
##106 [RX]
##107 [RX]
##109 [TX]
##111 [TX/RX]
##114 [RX]
##200 [RX]
##201 [TX/RX]
##204 [TX]
##220 [TX/RX]
##224 [TX/RX]
MultiPASS MP730/MP700 Chapter 4: Maintenance and Service
Definition
Document has jammed
Document is too long, or page time-over
Initial identification (T0/T1) time-over
Transmission cannot be made
Phase synchronization fails in OLD-FM
Password does not match for polling transmission
Recording paper has jammed or the recording paper has run out
Polling reception error
The other party has run out of recording paper
Auto dialing transmission error
The other party has rejected the machine during polling reception
Call fails
Memory has overflowed when receiving images
Image memory full by no ink error
Other party does not support ITU-T Color Faxing
Memory Communication reservation cancellation
Definition
The number allowed for retransmission of the procedure signal
was exceeded during transmission
The modem speed of the machine does not match that of the
other party
Fallback is not possible
EOL cannot be detected for 5 sec (15 sec if CBT)
RTN or PIN has been received
The procedure singal cannot be received for 6 sec while in wait
The transmitting machine cannot be use fallback
After transmitting DCS, a signal other than DIS, DTC, FTT,
CFR, and CRP was received, exceeding the permitted number of
transmissions of the procedure signal
Memory error
RTN was transmitted
During image reception, a carrier is not detected for 5 sec
DCN was received through a non-normal procedure
Receive DTC without Tx data
System error (e.g., main program may have gone away)
Fault occurred in the communication procedure signal
4-19