Table of Contents
Advertisement
MultiPASS MP730/MP700 Chapter 4: Maintenance and Service
5. SERVICE SWITCHES
5.1 Hardware Switches
There is no service hardware switch on the Circuit board.
5.2 Service Data Setting
Service data can be checked and changed with items on display menus. The effective SSSWs/
parameters and their default values in this fax machine are shown in 5.4 Service Data Flowchart
in this chapter. Detailed description of each SSSW/parameter is not given in this manual except
the new SSSWs/parameters added to this model. See G3 Facsimile SERVICE DATA
HANDBOOK (Rev. 0) (supplied separately) for details of them. The new switches for this model
are described in 5.6 New SSSWs/Parameters Added to this Model.
#1 SSSW (Service soft switch settings)
These setting items are for basic fax service functions such as error management, echo
countermeasures, and communication trouble countermeasures.
#2 MENU (MENU switch settings)
These setting items are for functions required during installation, such as NL equalizer and
transmission levels.
#3 NUMERIC Param. (NUMERIC parameter settings)
These setting items are for inputting numeric parameters such as the various conditions for the
FAX/TEL switching function.
#4 NCU (NCU settings)
These setting items are for telephone network control functions such as the selection signal
transmission conditions and the detection conditions, for the control signals sent from the
exchange.
#5 TYPE (TYPE setting)
The type setting makes the service data conform to a specific country communications
standards. There is only one setting item in this block.
#6 GENESIS (UHQ function setting)
These setting items are for scanned image processing such as edge enhancement and error
diffusion processing.
#7 PRINTER (PRINTER function settings)
These setting items are for basic printer service functions such as the reception picture
reduction conditions. Also there is an item for resetting the printer section without switching
the power off-on.
4-36
Advertisement
Table of Contents
