3.4.2 Connection procedure
Step 1 : Make sure that the power key is switched OFF.
Notes
•
The power is switched ON when pressing the [Power] key. In that case, press the key once
again to switch OFF the power.
Step 2 : Plug the power cable to the AC inlet at the back of the printer.
Notes
•
If the power cable is damaged, contact your local MUTOH dealer.
Notes
•
If you cannot use earth terminals nor find any of them, contact your local Mutoh distributor.
•
Do not unplug the power cable when the printer is on. If the power cable has been unplugged,
leave the printer for at least 1 minute before plugging the cable in again.
N°
1
AC inlet
2
Power cable
Name
29
AP-75740 – Rev 1.2 – 6/07/2011
User's Guide ValueJet 1204
Chapter 3: Installing the Unit