TOHATSU BFT 75A Owner's Manual page 44

CONTROLS AND FEATURES
<Display>
Steps 1
Outboard
—
motor
Display Switch ON
Not shown
Maintenance
Maintenance
indication on
indication
display
NMEA2000-compatible display:
• Follow instructions for the display.
• If the display allows selection of notification to be preset, select "Notify" (or
equivalent).
• Turn on the power supply to the display before turning on the ignition switch
of the outboard motor.
• The indication may differ, depending on the type of display.
When "Periodic Maintenance" is indicated:
1. Have the periodic maintenance performed without delay after returning to
port.
2. Reset the hour counter.
If not reset, the maintenance indication will remain in the display, and the
42
2 3
Ignition switch
Start engine
ON
— —
Shown Shown
Maintenance Maintenance
indication indication
hour count until the next
maintenance will be in error.
4
When the periodic maintenance is
conducted before "Periodic
Gear at F or R
Maintenance" is indicated, reset the
hour counter.
—
If not reset, the hour count until the
Not shown
next maintenance will be in error.
Maintenance
indication