Table of Contents
Advertisement
13.
regularly clean the power tool's
air vents. The motor's fan will draw
the dust inside the housing and ex-
cessive accumulation of powdered
metal may cause electrical hazards.
14.
do not operate the power tool near
flammable materials. Sparks could
ignite these materials.
15.
do not use accessories that re-
quire liquid coolants. Using water
or other liquid coolants may result in
electrocution or shock.
16.
Maintain labels and nameplates on
the tool. These carry important safety
information. If unreadable or miss-
ing, contact Harbor Freight Tools for a
replacement.
17.
Avoid unintentional starting. Prepare
to begin work before turning on the
tool.
18.
Do not leave the tool unattended with
the Battery Pack installed. Turn off
the tool, and remove the Battery Pack
before leaving.
19.
Use clamps (not included) or other
practical ways to secure and support
the workpiece to a stable platform.
Holding the work by hand or against
your body is unstable and may lead
to loss of control.
20.
The battery charger gets
hot during use. The
charger's heat can build
up to unsafe levels and
create a fire hazard if it does not
receive adequate ventilation, due to
an electrical fault, or if it is used in a
hot environment.
Do not place the charger on a flam-
SKU 66876
For technical questions, please call 1-800-444-3353.
mable surface. Do not obstruct any
vents on the charger. especially
avoid placing the charger on car-
pets and rugs; they are not only
flammable, but they also obstruct
vents under the charger.
21.
This product is not a toy. Keep it out
of reach of children.
22.
People with pacemakers should
consult their physician(s) before use.
Electromagnetic fields in close prox-
imity to heart pacemaker could cause
pacemaker interference or pacemak-
er failure. In addition, people with
pacemakers should:
• Avoid operating alone.
• Do not use with power switch locked
on.
• Properly maintain and inspect to
avoid electrical shock.
• Any power cord must be properly
grounded. Ground Fault Circuit Inter-
rupter (GFCI) should also be imple-
mented – it prevents sustained elec-
trical shock.
23.
WARNING: Some dust created by
power grinding, and other construc-
tion activities, contains chemicals
known [to the State of California] to
cause cancer, birth defects or other
reproductive harm. Some examples
of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and ce-
ment or other masonry products
• Arsenic and chromium from chemi-
cally treated lumber
Your risk from these exposures var-
ies, depending on how often you do
this type of work. To reduce your
exposure to these chemicals: work in
a well ventilated area, and work with
Page 7
Advertisement
Table of Contents
