Table of Contents
Advertisement
Unmodified plugs and matching out-
lets will reduce risk of electric shock.
avoid body contact with grounded
b.
surfaces such as pipes, radiators,
ranges and refrigerators. There is
an increased risk of electric shock if
your body is grounded.
c.
do not expose power tools to rain
or wet conditions. Water entering
a power tool will increase the risk of
electric shock.
d.
do not abuse the cord. never use
the cord for carrying, pulling or
unplugging the power tool or bat-
tery pack. Keep cord away from
heat, oil, sharp edges or moving
parts. Damaged or entangled cords
increase the risk of electric shock.
3.
personal safety
a.
stay alert, watch what you are do-
ing and use common sense when
operating a power tool. do not use
a power tool while you are tired
or under the influence of drugs,
alcohol or medication. A moment
of inattention while operating power
tools may result in serious personal
injury.
b.
use safety equipment. always
wear eye protection. Safety equip-
ment such as a dust mask, non-skid
safety shoes, hard hat, or hearing
protection used for appropriate condi-
tions will reduce personal injuries.
c.
prevent unintentional starting.
ensure the switch is in the off-po-
sition before connecting to power
source and/or battery pack, pick-
ing up or carrying the tool. Carry-
ing power tools with your finger on
the switch or energizing power tools
SKU 66876
For technical questions, please call 1-800-444-3353.
that have the switch on invites acci-
dents.
remove any adjusting key or
d.
wrench before turning the power
tool on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
e.
do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situations.
f.
dress properly. do not wear loose
clothing or jewelry. Keep your
hair, clothing and gloves away
from moving parts. Loose clothes,
jewelry or long hair can be caught in
moving parts.
g.
if devices are provided for the con-
nection of dust extraction and col-
lection facilities, ensure these are
connected and properly used. Use
of these devices can reduce dust-
related hazards.
h.
only use safety equipment that
has been approved by an appropri-
ate standards agency. Unapproved
safety equipment may not provide
adequate protection. Eye protection
must be ANSI-approved and breath-
ing protection must be NIOSH-ap-
proved for the specific hazards in the
work area.
4.
power tool use and care
a.
do not force the power tool. use
the correct power tool for your ap-
plication. The correct power tool will
do the job better and safer at the rate
for which it was designed.
b.
do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be con-
Page 4
Advertisement
Table of Contents
