Table of Contents
Advertisement
Clearing the Dynamic Range
The DR500 allows you to program and store up to 10 channels with
specific dynamic range settings. If you have exceeded the 10-channel
maximum, the DR500 front panel displays FUL indicating the memory is
full. When FUL displays, the DR500 memory must be cleared before
additional dynamic range settings can be entered. To clear the DR500
memory, press:
The front panel will momentarily display CLr as the DR500 clears all
dynamic range settings from memory. When the DR500 has finished
clearing all settings, the current channel displays.
Setting the Dynamic Range Global Default
To set one dynamic range for all authorized channels:
1. Press:
2. Enter the dynamic range code using the TUNE ? and TUNE ?
buttons to make your selection, then press STORE.
All channels are set to the specified dynamic range. To change or clear
the global dynamic range default setting, repeat this procedure.
Setting the Transponder Frequency
The DR500 is shipped with the transponder frequency saved in memory.
It is highly unlikely that this frequency will have to be changed and should
only be done upon instructions from your DMX MUSIC affiliate. In the
event that a new transponder frequency must be entered, follow these
procedures:
1. Press:
Advertisement
Table of Contents
