Table of Contents
Advertisement
USE CORRECT POWER SOURCE
Operate the wall mount power supply for the DR500 from a 120 V, 60 Hz
outlet only. Take care not to overload wall outlets or extension cords,
as this increases the risk of fire or electrical shock.
ROUTE POWER CORDS SAFELY
Route power cords so they are not walked on or pinched. Pay particular
attention to cords and connections at the plugs, receptacles (such as
power strips), and the point where they exit from the DR500 and attach to
other equipment. Do not place any items on or against power cords.
USED APPROVED ATTACHMENTS ONLY
Use only DMX MUSIC -approved attachments with the DR500 Receiver.
Connecting the DR500 to Your Audio System
If your DR500 system has not been professionally installed, if you have
disconnected your DR500 Receiver, or if you are adding a component,
refer to the following steps and diagrams to help you connect your
system.
If you have questions or need assistance connecting any components to
your DR500, please contact your DMX MUSIC affiliate.
To connect multiple DR500 Receivers to one antenna, refer to the
appropriate section later in this chapter.
Connection Guidelines
It is important that you follow these guidelines when making any DR500
system connection:
•
Do not plug the Receiver into an AC outlet until all connections
have been made and you have read the Startup procedures in
Section 3: Getting Started and Basic Operations.
•
Turn the audio system amplifier OFF and the volume completely
down.
Advertisement
Table of Contents
