Connecting The Dr500 To Your Monaural System - DMX DR500 User Manual

Do not connect the RCA cables from the DR500 to the PHONO input of
audio equipment. Any line level input such as AUX, CD, DAT, TAPE,
VIDEO, or VCR can be used for the DR500 output.
4. Plug the DR500 into an AC outlet.
5. Continue on to Section 3: Getting Started and Basic Operations.

Connecting the DR500 to Your Monaural System

To connect the DR500 to a monaural system, refer to the figure below
and the following instructions.
1. Make sure the monaural amplifier is OFF and the volume is turned
completely down.
2. Connect an RCA cable to the MONO jack on the back of the
DR500.
? Connect the other end of the RCA cable to any available input on the monaural
equipment EXCEPT the phonograph input.
4. Plug the DR500 into an AC outlet.
5. Continue on to Section 3: Basic Operations.
Do not connect the RCA cables from the DR500 to the PHONO
input of audio equipment. Any line level input such as AUX, CD,
DAT, TAPE, VIDEO, or VCR can be used for the DR500 output.