Connecting The Dr500 To Your Stereo System - DMX DR500 User Manual

• Connections should be finger-tight only; never use pliers or a
wrench.
• The DR500 Receiver wall mount power supply is polarized, and
only one orientation on the wall or power strip is acceptable.
• The DR500 Receiver should not be plugged into an AC socket
like those found on the rear of audio amplifiers.
• Once the DR500 is connected, turned on, and receiving the satellite
signal, it should remain plugged in to an unswitched AC outlet so that
it can receive any programming updates, authorization commands,
and information from the DMX MUSIC/DBS National Authorization
Control Center.
If the DR500 will not be used for extended periods of time, it
should be turned off using the front panel power switch only. It
should not be unplugged nor have its AC power turned off.

Connecting the DR500 to Your Stereo System

To connect the DR500 to a stereo system, refer to the figure below and
the following instructions.
1. Make sure the stereo amplifier is OFF and the volume is turned
completely down.
2. Connect the RCA stereo cables to the L(eft) and R(ight) STEREO
jacks on the back of the DR500.
3. Connect the other end of the RCA cables to any high-level input
on your stereo equipment EXCEPT the phonograph input.
Remember to match left and right channels.