Using Tv Remote Controller - Onkyo LS-T10 Instruction Manual

Using TV Remote Controller

Preprogrammed functions: This unit has been preprogrammed so that it can be
operated with your existing TV remote controller. The functions that can be operated are volume
control (+/–) and muting (
TV remote controller, you can use the learning function as below to enable the operation.
‡
The mute state can be turned over each time you press the Mute button on your TV
remote controller. In such case, you can synchronize the mute status of the unit and the
TV by pressing and holding the Mute button on your TV remote controller.
‡
To disable the preprogrammed function, press and hold first
10 seconds. When the preprogrammed function is successfully disabled,
flashes 3 times, then any TV remote controller cannot be used to operate the unit. When
you want to re-enable the preprogrammed function, perform the same operation. When
the preprogrammed function is successfully re-enabled,
you can use any remote controller using preprogrammed function.
To control the preprogrammed functions: Varieties of TV remote controllers have been
preprogrammed on this unit, which may lead to unintended operation from the other remote
controller than your TV remote controller. In such case, press and hold first
press either volume or mute button on your TV remote controller 2 or 3 times to turn on the controlling
function. When the controlling function is set to on, the
other remote controller cannot be operated.
‡
Controlling function may not be set to some TV remote controllers.
‡
To cancel the controlling function, press and hold first
the controlling function is successfully cancelled,
remote controller using preprogrammed function.
Learning function: You can operate the unit with a TV remote controller by assigning
the functions to the buttons of the remote controller. Perform the following button
operation, when the
control sensor of this unit and press the button to assign on the TV remote controller 3 times.
When the Learning function is successfully set,
* Press button first when pressing and holding the buttons together.
Learning function
ON/STANDBY
VOLUME +
VOLUME –
). If you want to use other functions or cannot operate with your
indicator starts flashing, direct your TV remote controller to remote
Button operation (Press simultaneously for 3 seconds)
17
, and then
indicator flashes once, then
and then
indicator flashes twice, and then, the
, and then for about 10 seconds. When
indicator flashes once, then you can use any
indicator flashes twice.
o
o
o
for about
indicator
, and then