Remote Controller - Onkyo LS-T10 Instruction Manual

If smoke, smell or abnormal noise is produced
by the unit, unplug the power cord from the
wall outlet immediately and contact your
Onkyo dealer.
Audio
There's no sound, or it's very quiet
‡
Make sure that all audio connecting plugs
are pushed in all the way. (oP.7, 8)
‡
Make sure that the input of device is
connected properly. (oP.7, 8)
‡
When the Status indicator flashes in
white, the muting is enabled. Press
or Volume –/+ on the remote
controller or the Volume +/– buttons
simultaneously on the unit to disable
the muting. (oP.14)
‡
Make sure that none of the connecting
cables are bent, twisted, or damaged.
The base sound cannot be heard
‡
The protection circuit in the subwoofer
may have tripped due to a rise in
temperature. Disconnect the power
cord from the outlet and reconnect after
a while.
Noise can be heard
‡
Do not bind the power cord, connection
cables and other audio cables with a band.
‡
An audio cable may be picking up
interference. Try repositioning your
cables.
‡
Make sure that there is no obstacle or
reflection between the unit and the
subwoofer.

Remote Controller

The remote controller doesn't work
‡
Make sure that the battery is installed
with the correct polarity. (oP.13)
‡
Make sure that the remote controller
is not too far away from the unit, and
that there's no obstruction between the
remote controller and the unit's remote
control sensor. (oP.13)
‡
Make sure that the unit is not subjected
to direct sunshine or invertertype
fluorescent lights. Relocate if necessary.
19