Using The Remote Controller; Replacing The Battery - Onkyo LS3200 Instruction Manual

Using the Remote Controller

Remove the plastic film before using the
remote controller.
To use the remote controller, point it at the
controller's remote control sensor, as shown
below.
(Placing on the floor, etc.)
Remote control
sensor
(Mounting to the wall)
Remote control
sensor
Remote control
sensor
En
8
LAP-302
Approx.
16ft. (5m)
LAP-302
Approx.
16ft. (5m)
LAP-302
Approx.
16ft. (5m)

Replacing the Battery

Use only a battery of the same type (CR2025).
Pull out firmly in the direction of the arrow
pressing the tab in the direction of the arrow.
Push
Pull
Positive ⊕ side
Note
• If the remote controller doesn't work reliably, try
replacing the battery.
• If you intend not to use the remote controller for a
long time, remove the battery to prevent damage
from leakage or corrosion.
• Remove expired battery as soon as possible to
prevent damage from leakage or corrosion.
Caution
• Replacing the battery incorrectly may cause an
explosion. Use only a battery of the same type or an
equivalent.
Back side