Using A Tv Remote Controller - Onkyo LS-T30 Instruction Manual

Using a TV Remote Controller

Preprogrammed feature
The unit has been preprogrammed so that the unit
can be operated using your TV remote controller.
Volume control and muting(*) operations can be
performed with this feature. If you want to use other
functions or cannot operate the unit with your TV
remote controller, you can use the learning function
(described below) to enable these features.
To cancel this feature, press and hold
approximately 3 seconds while continuing to
press and hold on this unit The input source
indicator will flash (white) for 10 seconds. Do not
operate the unit during this time. Afterwards, it
will flash 3 times to indicate that this feature has
been cancelled. Perform the same procedures to
use the TV remote controller again.
* The mute state can be turned over each time you
press the Mute button on your TV remote controller.
In such case, you can synchronize the mute status of
the unit and the TV by pressing and holding the Mute
button on your TV remote controller.
Learning function
The unit is set so that signals emitted from each
button on your TV remote controller control
specific operations.
* It is recommended to select buttons that do not
prevent TV operation when assigning the functions
to your remote controller. Signal of some types of
remote controller may not be received by the unit.
E.g.) To assign the unit's ON/STANDBY
function to the TV remote controller:
1. Press the button on the unit for
approximately 3 seconds while pressing and
holding the button. The input source
indicator (white) flashes for 10 seconds.
2. While the input source indicator is flashing,
press any button on the TV remote controller
3 times while aiming it at the remote control
signal sensor of the unit.
The indicator flashes twice (white) to indicate
that this was successfully configured. After
this is set, pressing the button on the TV
remote controller will enable ON/STANDBY
operation on the unit.
The learning function enables the following unit
functions to be operated with your TV remote
for
controller. Press and hold the following buttons
instead of
- VOLUME i:
- VOLUME j:
- MUTING:
- INPUT:
- SOUND MODE:
To prevent incorrect operation:
The unit is preprogrammed to support a large
number of TV remote controllers. For this
reason, using remote controllers other than
that supplied with the unit and TV remote
controllers may result in unexpected operation.
To prevent incorrect operation, press and
hold on the unit, and then press and hold
while continuing to press
seconds. The input source indicator will flash
(white) for 10 seconds. During this time, aim
the TV remote controller toward the unit and
press either the volume button or mute
button once. The input source indicator will
flash twice (white), which indicates that the
unit will not accept signals emitted when
buttons are pressed on remote controllers
other than the supplied remote controller or
the TV remote controller.
0 Controlling function may not be set to
some TV remote controller.
in step 1.
and
and
and
for 3
11