HIKVISION 5-inch High-definition Network Speed Dome User Manual page 85

User Manual of Network Speed Dome
2. Check the checkbox of Enable Record Schedule to enable scheduled recording.
3. Set the record parameters of the speed dome.
 Pre-record: The time you set to start recording before the scheduled time or
the event. For example, if an alarm triggers recording at 10:00, and the
pre-record time is set as 5 seconds, the speed dome starts to record at
9:59:55.
The Pre-record time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s,
25 s, 30 s or not limited.
The pre-record time changes according to the video bitrate.
 Post-record: The time you set to stop recording after the scheduled time or
the event. For example, if an alarm triggered recording ends at 11:00, and the
post-record time is set as 5 seconds, the speed dome records until 11:00:05.
The Post-record time can be configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min
or 10 min.
 Overwrite: If you enable his function and the HDD is full, the new record files
overwrite the oldest record files automatically.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Figure 7-5 Recording Schedule Interface
Figure 7-6 Record Parameters
84