HIKVISION 5-inch High-definition Network Speed Dome User Manual page 45

5-inch high-definition network speed dome

Hide thumbs Also See for 5-inch High-definition Network Speed Dome:

Table of Contents

User Manual of Network Speed Dome

Time(DST) functions for setting the time. Time Synchronization consists of auto

mode by Network Time Protocol(NTP) server and manual mode.

To enter the Time Settings interface:

Configuration > Basic Configuration > System > Time Settings

Or Configuration > Advanced Configuration > System > Time Settings

 Configuring Time Synchronization by NTP Server

Steps:

(1) Check the radio button to enable the NTP function.

(2) Configure the following settings:

Server Address: IP address of NTP server.

NTP Port: Port of NTP server.

Interval: The time interval between the two synchronizing actions by NTP server.

It can be set from 1 to 10080 minutes.

If the speed dome is connected to a public network, you should use a NTP server

that has a time synchronization function, such as the server at the National Time Center (IP

Figure 6-2 Time Settings

Figure 6-3 Time Sync by NTP Server

Table of Contents