Configuring Video Tampering Alarm - HIKVISION 5-inch High-definition Network Speed Dome User Manual

76
User Manual of Network Speed Dome
Figure 6-45 Video Loss
2. Check the Enable Video Loss Detection checkbox to enable the video loss
detection.
3. Click to edit the arming schedule for video loss detection. The
arming schedule configuration is the same as the setting of the arming schedule for
motion detection. Refer to Step 2 Set the Arming Schedule for Motion Detection in
Section 6.6.1.
4. Check the checkbox to select the linkage method taken for the video loss alarm.
Notify surveillance center, send email and trigger alarm output are selectable. Please
Step 3 Set the Alarm Actions for Motion Detection in Section 6.6.1.
5. Click to save the settings.

6.6.3 Configuring Video Tampering Alarm

Purpose:
You can configure the speed dome to trigger the alarm actions when the lens is
covered.
Steps:
1. Enter the video tampering Settings interface:
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.