Alarm Device Setup - iCanTek iCanView220 User Manual

iCanView220/220W User's Guide

5.8. Alarm Device Setup

Used for testing alarm outputs via manual activation. This pages also assigns the alarm device
name, sensor type and "time out"/duration.
Sub Field
Field/Button
/Button
Alarm Device
Test
Sound Test
Alarm Device
Sensor
Active
Condition
Motion
Duration
SAVE
Figure 5-10. Alarm Output Setup
Click here to manually activate the output (On/Off) for testing
The small box to the far right, with the white background,
indicates the status of the relay by On/Off.
ON On the alarm output (closes the relay contact)
OFF Off the alarm output (opens the relay contact)
Define the condition for activating the alarm device.
Select sensor, or motion detection.
Name Define the logical name for the alarm device.
Check the box to the left. This enables the alarm feature for
the specified sensor condition.
Check the box to the left. This enables the alarm feature for
the specified internal motion detection condition.
Set the duration of Alarm annunciation (alarm timeout).
10 sec, 30 sec, 1 min, 2 min, 5 min, 10 min, 30 min, 1 hour.
Saves the setup parameters.
Description
Rev.1.0 (Aug. 2006)
37