Hardware Installation (Ews370Ap/Ews371Ap) - EnGenius EWS371AP User Manual

Hardware Installation
(EWS370AP/EWS371AP)
1. Connect one end of the Ethernet cable into the LAN port
of the Access Point and the other end to the Ethernet
port on the computer.
2. Connect the Power Adapter to the DC-IN port of the
Access Point and plug the other end into an electrical
outlet.
3. Screw on the provided antennas to the top of this device.
(EWS371AP only)
This diagram depicts the hardware configuration.
2
1
Note: The Access Point supports both IEEE 802.3at PoE
(Power over Ethernet) or the included power adapter.
You may use either one as the power source. DO NOT
use both at the same time.
17