Operating the DisplayPort Detective Plus
The table below provides a status summary of the Power LED.
LED
Status
Power
Solid blue
Solid red
Flashing
blue
In order for the DisplayPort Detective Plus to pass HDCP content (e.g. Blu-ray, etc.), set
DIP switch 4 to the ON (down) position.
After setting DIP switch 4 to the ON position, reboot the DisplayPort Detective Plus by
disconnecting and then reconnecting the power.
IMPORTANT: When enabling or disabling HDCP pass-through, the
DisplayPort Detective Plus must be power-cycled in order for the
DIP switch setting to take effect.
Conditions
•
Detective is powered
•
HPD is high
•
EDID has been successfully written
(to a EDID bank or the local input)
•
Bad EDID
•
HPD is low
•
EDID is being read from sink
•
EDID is being read from EDID bank
Passing HDCP Content
DIP switch 4 in
ON position
page | 9
EDID Programming
Page Title