Star TSP650 SERIES Hardware Manual page 27

Adjustment value according to the paper you are using
Paper
Thickness
ø12 (A) inner diameter / ø18 (B) outer di-
(µm)
Detected diameter (C)
Level 1
65 Approx.
ø23
85 Approx.
ø23
C
B
A
Paper roll core
Horizontal (standard) Layout
ameter core roll paper
Remaining paper
(mm) length (m)
Level 2 Level 1
Approx. Approx.
ø29 2.5
Approx. Approx.
ø29 1.9
Notes:
1) The adjuster is factory-set at level 1.
2) The detected diameter and remained paper length given
3) If thick paper is used (paper thickness between
C
Vertical Layout or Wall-Mount
ø12 (A) inner diameter / ø18 (B) outer di-
Detected diameter (C)
Level 2 Level 1
Approx. Approx.
6.3 ø23
Approx. Approx.
4.8 ø23
in the table are calculated values, and there are some
variances depending on the rolled state of the paper,
the actual mechanism, or the printing pattern.
80 µm and 85 µm), the paper roll may loosen and
cause variances in the detected values. Therefore,
setting the adjuster to Level 2 is recommended.
– 23 –
ameter core roll paper
Remaining paper
(mm) length (m)
Level 2 Level 1
Approx. Approx.
ø29 2.5
Approx. Approx.
ø29 1.9
Level 2
Approx.
6.3
Approx.
4.8