Hints And Tips - Logik L712WM11 Installation Manual / Instruction Manual

Hints and Tips

Problems
Buttons don't work
Door doesn't open
If you start a wrong
programme accidentally.
Unusual odour
You can't see any water
There's no water going into
the washing machine
There's only a small amount
of water
Water adds up during
washing
Water drains away during
washing
There's no water going into
the washing machine during
rinse operation
Rinsing begins before the
spinning finishes
During the spin-dry, the
drum stops and rotates
several times
Foam and water remain in
the door or door seal
Spin starting is repeated
Wash time too long
L712MW11_IB_final110506.indd 19
Solutions
• Key lock is activated. Deactivate the key lock function.
• The washing machine is operating a programme.
• The Programme Dial was turned to a different programme.
Door lock may be active.
First press Start/Pause button or turn the Programme Dial to "Off".
Secondly turn the Programme Dial to the correct programme, then
select the temp, spin speed or optional function you want. Press the
Start/Pause button to start the new programme. (Note: We suggest that
you do not change the programme after the machine has been running
for 3 minutes.)
• Rubber parts may give off a smell when you first start using the
washing machine, but this goes away over time.
• You should wash the drum once a month.
This is normal: The water level is below the window.
• The water tap might be turned off.
• The water hose or water-supply hose may be frozen.
• Your water supply may be disrupted.
• The water-supply valve filter may be clogged.
• If you have paused the programme and you restart, the washing
machine may drain some water.
• Don't pour water in through the door.
This is normal: water is supplied automatically as the level lowers, and
with heavy loads the water may fill up repeatedly.
This is normal: water often drains and refills to wash off excess foam.
(This is called foam detection.)
Before rinsing, the washing machine spins to drain water remaining from
the wash. The water will fill up after that.
• If your laundry has collected to one side of the drum, rinsing will
start automatically to correct the imbalance.
• If there's excess foam after washing, water may drain and refill to
wash it off. (This is called foam detection.)
This is normal. The washing machine has detected an unbalanced load
and is trying to correct it.
Although foam and water may remain, it does not have any influence on
the performance of a rinse.
This is normal. Although spin starting may be repeated, it is a function
made to spin quietly.
During washing, if the laundry is unbalanced, the machine will try to
correct by slowly rotating the drum. This may take several attempts. This
is normal.
19
24/05/2011 5:49 PM