First Steps - Televes zAshd User Manual

5. First steps

After the wiring is complete, the mains adapter plugged,
and the ZAS HD SAT powered ON with the RCU (press
button , it needs some time to make a self-check and
)
be ready to work.
The front LED fl ashes during this period. Do not switch off
the receiver or press any key.
The welcome screen is activated automatically and will
guide you in confi guring the menus and in searching
channels.
You must fi rst specify the language in which you want to
display on-screen menus.

Choose the language in which menus are displayed on
screen using the cursor keys

Press OK to confi rm.
On the next screen you must specify the geographical area
where the receiver is installed and the TV display format
you need (4:3 or 16:9).
Location must be correct because of this data depends a
correct indication of the time displayed on the menus.

Select one of these options using the cursor keys
, and in each one, change the value using the cursor keys
.
or

Press OK to confi rm the values and continue.
This receiver features a preprogrammed list of channels
which can be activate at this time. This list may already
contain all the channels you want, so it would not be
necessary to perform a full channel search.
Depending on the country selected in the previous section,
select the appropriate list.
- Press OK key to accept the pre-programmed list and fi nish
the installation, or press EXIT key to make a full search.
- The load of the list of pre-programmed channel
is designed for a simple confi guration, consisting
only of antenna and LNB.
If your installation does not correspond to it (has
additional elements like DiSEqC, Motor,... etc.)
we recommend performing a full satellite search.
.
or
or
9
EN