Canon MV300 Instruction Manual page 45

2. Press the PHOTO button fully down to take the still picture.
• The camera takes the image immediately, and then records the "photo" to
the tape for approximately six seconds. During this time the camera also
records the sound, and the display shows the still picture.
• A counter display appears, and counts up to six seconds as the camcorder
records the picture. F disappears from the display.
• While the camera records the still, you cannot use the camera functions
(controls, POWER switch/zoom lever, etc., do not respond until recording is
complete). This applies even when you haven't loaded a cassette.
• The wireless controller's PHOTO button has no half-way setting. Press the
button fully and the camera immediately takes the "photo".
• Only take "photos" where it is bright enough to see the image in the display.
• If you want to use an effect, make sure you set it before you take your picture.
E
45