Notes On Using The Batteries - Canon MV300 Instruction Manual

Notes on Using the Batteries

Charging and recording times
• These times vary — the safest policy is always to have two or three times as
many battery packs as you think you will need.
• You will get more recording time if you turn the camera off between shots,
instead of leaving it in record pause mode.
Battery pack
Time needed for
full recharge
Maximum
recording time
• Recording time will be shorter than usual at low temperatures. You can use the
battery pack between 0° to 40°C (32° and 104°F), but it works best between 10°
to 30°C (50° and 86°F).
• If the battery pack starts to give you much less recording time than usual, it has
reached the end of its life and must be replaced.
•
These figures show how long you can view playback with the LCD, after attaching a
fully-charged battery pack. Playback time will be shortened at low temperatures.
Battery pack
BP-511
BP-522
How much power is left?
The indicator in the display shows you
approximately how much charge the
battery pack has left:
• "CHANGE THE BATTERY PACK"
appears in the display for four
seconds when the power is
completely exhausted. The empty
battery mark then appears and starts
to flash. The power indicator light
also flashes.
• The indicator is not constant —
different levels will be shown when
you subject the battery pack and
camcorder to different conditions.
Using the viewfinder:
Using the LCD screen:
Playback time (using the LCD screen)
BP-511 BP-522 (optional)
1 hr. 35 min.
2 hr. 30 min.
2 hr.
2 hr. 10 min.
4 hr. 25 min.
100%
↓
75%
↓
50%
↓
25%
↓
CHANGE THE BATTERY PACK
↓
2 hr. 35 min.
5 hr. 10 min.
4 hr. 5 min.
0%
87
E