Canon MV300 Instruction Manual page 43

Setting the clock
After you set the date and time, the date/time and home time zone will be
displayed for about four seconds each time you turn the power on.
( 35)
1. Set the camera to record pause mode.
2. Open the menu and select D/TIME SET.
• The year display starts to flash.
3. Turn the selector dial up and down to change the year. Press the
dial in to move to another part of the display.
• Once you move from the year, the next part of the display starts flashing.
4. Set the month, day, hours, and minutes in the same way.
5. Press the MENU button when finished, and to start the clock.
• The date can be set to any year between 2000 and 2050.
• If you press the MENU button in the middle of setting the date and time, you
leave the menu, and the clock starts.
• If you press the selector dial in after setting the minutes you can set the date
and time again from the start.
Date and time display
You can choose to display or hide the date and time display during recording.
When the date and time display is set to ON, the date and time show in the lower
left-hand corner of the display but the time zone disappears in about four seconds.
The large, four-second display will no longer appear when you turn on the power.
It is not recorded onto your tape.
( 35)
1. Set the camera to record pause mode.
2. Open the menu and select D/T DISPLAY.
3. Select ON and close the menu.
D/TIME SET•• 1.JAN.2000
12:00 AM
D/T DISPLAY•OFF
E
43