Table of Contents
Advertisement
3.
Go to Remote Dial-In Users. Click on one index number to edit a profile.
4.
Set Dial-In settings to as shown below to allow the remote user dial-in to build VPN
connection.
If an IPSec-based service is selected, you may further specify the remote peer IP Address,
IKE Authentication Method and IPSec Security Method for this Dial-In connection.
Otherwise, it will apply the settings defined in IPSec General Setup above.
If a PPP-based service is selected, you should further specify the remote peer IP Address,
Username, Password, and VJ Compression for this Dial-In connection.
Vigor3100 Series User's Guide
95
Advertisement
Table of Contents
Need help?
Do you have a question about the Vigor 3100 Series and is the answer not in the manual?