Shelving; Door Options - Perlick 24" Signature Series Operation & Installation Manual

cAutIOn
the louvered toe plate must be removed to service the unit.
the floor cannot interfere with removal. the louvered sec-
tions must not be covered or obstructed to prevent proper
air circulation.

SHElvInG

IMPOrtAnt: to achieve maximum performance, interior lou-
ver openings and fan guard openings should never be
obstructed.
freezer/refrigerator
the single door unit comes standard with black vinyl coated
adjustable full extension pullout shelves.
Wine reserve
the single door unit comes standard with six full extension
black vinyl coated wine racks capable of storing 48 total wine
bottles. Shelves are removable and adjustable to accommo-
date oversized (magnum) bottles. Additional storage is avail-
able on the lower step for of an five wine bottles.
beverage center
the single door unit comes standard with two full extension
black vinyl coated wine racks and one industry exclusive full
extension pullout shelf allowing for storage of both wine and
beverages. Shelving positions are adjustable.
Adjusting full Extension Shelving
. Pull the shelf out to its farthest position. locate the tabs
in the middle of both extenders (figure 4). lift one tab up
while pushing the opposite tab down and pull shelf out.
2. reposition each bracket separately. Grasp the middle of
the bracket, pull the front end up and out, then forward
to remove (figure 5).
3. Place bracket at the desired position. Push the rear hook
into the rear key slot. Set front of bracket on the wall
hook.
4. repeat for other bracket(s).
5. Push extenders completely into the unit. Align the shelf
grooves with the extenders and slide completely into the
unit.

dOOr OPtIOnS

Perlick residential units offer a variety of door panel design
alternatives; solid stainless steel, solid wood overlay, stainless
steel glass and wood overlay glass.
Solid stainless steel and stainless steel glass doors are shipped
from the factory with decorative stainless steel panels and
handles in place on the appliance.
Solid wood overlay and glass wood overlay doors are designed
to accept a decorative front panel to match surrounding cabi-
6
24" Signature Series Operation / Installation Manual
Lift one tab up while pushing the
opposite tab down and pull shelf out
figure 4. Sliding Shelf Extender tabs
To remove brackets,
remove shelf, lift front
of bracket to disengage
the front key slot, and
pull forward to disengage
the rear key slot.
figure 5. Sliding Shelf Mounting brackets
netry and door handles. the panel and door handles are sup-
plied by the customer.
All Perlick units accept any of the above door configurations
and are fully interchangeable.
IMPOrtAnt: Glass with stainless trim and glass with wood
trim may sweat in conditions with relative humidity over
75%.
WOOd OvErlAy InStAllAtIOn
before beginning installation, check all components for prop-
er fit and finish.
WArnInG
• All overlay doors required a trim panel at least 3/4" thick.
© 2009