Installation; Shelving - Perlick HA24RB4R Installation Manual

Table of Contents

Advertisement

INSTALLATION

CAUTION
Finished flooring should be protected with appropriate material
to avoid damage from moving the unit.
If unit has been laid on its back or sides, place unit upright and
allow minimum of 24 hours before connecting power.
1. Plug the unit into the 15 amp grounded outlet located in the instal-
lation opening. With power applied to the unit, check that lighting
and cooling function operate properly, then turn off power to the
wall outlet at the circuit breaker.
WARNING
Shut off power to the wall outlet before installing unit into the
opening.
2. Check that the following are level and square:
- front face and interior opening
- installation opening and floor surface
- countertop bottom front edge
IMPORTANT: The floor under the unit must be at the same level as the
surrounding finished floor.
3. If all surfaces are level, refer to Figure 3 and perform the following:
a. Measure from the floor to the bottom of the front edge of the
countertop.
b. Measure the rear of unit cabinet from floor to top of cabinet, at
back corners.
c. Adjust rear legs so B measurement equals A measurement.
Using an adjustable wrench or pliers, turn legs counterclock-
wise to raise the unit or clockwise to lower the unit.
IMPORTANT: Levelling legs should not extend more than 3/4" from
bottom of unit.
4. Slide the unit into position. Make sure the rear leveling legs slide
under the anit-tip brackets. Push the unit into the opening until the
door is flush with the surrounding cabinetry, or until the rear legs
are tight against the anti-tip brackets.
IMPORTANT: The rear leveling legs must be engaged under the anti-
tip brackets.
5. Shim the front of the unit so the front door is flush with the sur-
rounding cabinetry. Adjust the front legs to support the countertop
at the shimmed height. Using an adjustable wrench or pliers, turn
legs counterclockwise to raise the unit or clockwise to lower the
unit. Countertop should be resting on top of the unit.
IMPORTANT: If countertop is not resting entirely on unit top, shim the
countertop to prevent damage to the countertop.
4
24" ADA-Compliant Series Operation / Installation Manual
Figure 3. Leveling
CAUTION
To prevent damage to the countertop and unit underneath, do not
place heavy objects on countertop directly above the unit.
6. Check interior door openings inside unit and ensure unit is level.

SHELVING

IMPORTANT: To achieve maximum performance, interior louver open-
ings and fan guard openings should never be obstructed.
Refrigerator
The single door unit comes standard with two black vinyl coated
adjustable full extension pullout shelves.
Wine Reserve
The single door unit comes standard with five full extension black vinyl
coated wine racks capable of storing 40 total wine bottles and addi-
tional storage on the bottom for 8 more bottles. Shelves are removable
and adjustable to accommodate oversized (magnum) bottles.
© 2009

Advertisement

Table of Contents
loading

Table of Contents