Switching The Server On And Off - Fujitsu PRIMERGY TX120 S3 Operating Manual

Starting up and operation
6.4

Switching the server on and off

V
CAUTION!
If nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see section
stripes on monitor screen" on page
The On/Off button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug(s).
Switching the server on
The power-on indicator (item 11 in
– Starting up for the first time:
I
For the Japanese market, please refer to the " はじめにお読みくださ
い ".
Ê Press the On/Off button (item 12 in
The power-on indicator lights green (item 11 in
Ê Insert the PRIMERGY ServerView Suite DVD 1 in the DVD drive.
Ê Follow the on-screen instructions (see also
onboard SATA controller" on page 70
and installing the operating system without the ServerView Installation
Manager" on page
– System already installed:
Ê Press the On/Off button (item 12 in
The power-on indicator lights green (item 11 in
The server is switched on, performs a system test and boots the
operating system.
Switching the server off
Power-on indicator (item 11 in
Ê Shut down the operating system properly.
The server is automatically switched off. The power-on indicator lights up
orange.
68
79).
figure 13 on page
figure 13 on page
72).
figure 13 on page
figure 13 on page
Operating Manual
59) lights orange.
59).
figure 13 on page
section "Configuring the
or section "Configuring the server
59).
figure 13 on page
59) lights green.
"Flickering
59).
59).
TX120 S3