Fujitsu PRIMERGY TX120 S3 Operating Manual page 32

Important information
Before starting up
V
CAUTION!
During installation and before operating the device, observe the
instructions on environmental conditions for your device (see
"Server specification" on page
If the server has been moved from a cold environment, condensation
may form both inside and on the outside of the machine.
Wait until the server has acclimatized to room temperature and is
absolutely dry before starting it up. Material damage may be caused
to the server if this requirement is not met.
Only transport the server in the original packaging or in packaging
that protects it from impacts and jolts.
Installation and operation
V
CAUTION!
This unit should not be operated in ambient temperatures above
35 °C.
If the unit is integrated into an installation that draws power from an
industrial power supply network with an IEC309 connector, the power
supply's fuse protection must comply with the requirements for non-
industrial power supply networks for type A connectors.
The unit automatically adjusts itself to a mains voltage in a range of
100V - 240V. Ensure that the local mains voltage lies within these
limits.
This device must only be connected to properly grounded power
outlets or insulated sockets of the rack's internal power supply with
tested and approved power cables.
Ensure that the device is connected to a grounded power outlet close
to the device.
32
27).
Operating Manual
section
TX120 S3