Kenmore 415.16649010 Use & Care Manual page 19

9
Remove the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to cart left side
panel with the nut, shown A.
Insert AA battery into ignition module, negative (
Untie the 7 burner ignition wires bundled under the right side of grill head. Draw the wires over the cart partition panel.
Connect each of the ignition wires from the main burner electrodes and sideburner electrode into the back of the Electronic
Ignition Module. Total (7) connections.
Untie the two wires [(a) and (b)] from under the left side of grill head.
wiring harness into the back of the Electronic Ignition Module.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in locations shown as (a),(b).
Use one of the bundling ties to bundle the 9 wires together, and tie to the gas line hose so that the wires don't
hang down into the cabinet.
A
Nut
B
Cap
10
Insert front brace under control panel and between cart side panels. Secure using two 1/4-20x1
washers and 7mm flat washers on each side, shown A.
Under front brace, secure cart partition panel to front brace using one #8-3/8" tapping screw, shown B.
washer
7mm Lock
Qty.4
A
-
) end first. Then put on the cap, shown B.
Electronic
ignition module
Heat shield
-
+
AA battery
7mm flat washer
Qty.4
Connect the two wires [(a) and (b)] from the switch
Total (2) connections.
#8-3/8" tapping screw
Qty.1
B
¾
1/4-20x1 "
Screw
7mm flat
7mm lock
Washer
Washer
4
1
(a)
5
2
6
3
7 (b)
.
¾
" screws, 7mm lock
¾
screw
1/4-20x1 "
Qty.4
#8-3/8" tapping screw
464224010 • 19