Synchronous Mode - Fujitsu SK-96390-100PMC User Manual

4) After programming the Flash-device, switch off the power supply and set back the
mode according to the usage of the application, e.g.:
DIP-Switch S2
(RUN Mode)
5) Power on the board. The user application is started directly.

4.2 Synchronous Mode

In order to program the Flash-ROM synchronously special third-party soft- and hardware has
to be used, e.g. GALEP-4 from www.conitec.de. This tool is not available for free.
A dedicated Flash programming socket (X17) is provided on the evaluation-board for direct
connection to this programmer.
X17: Flash programming socket
© Fujitsu Microelectronics Europe GmbH
SK-96390-100PMC User Guide
Chapter 4 Programming the internal Flash memory
MD0 MD1 MD2 nc
1 2
Figure 4-1: Flash Programming Socket
- 27 -
ON
OFF
3 4
n/c 1 2 P10_3
MD0 3 4 n/c
RST 5 6 SIN2
SOT2 7 8 SCK2
VCC 9 10 GND
UG-960017-11