Table of Contents
Advertisement
4) After programming the Flash-device, switch off the power supply and set back the
mode according to the usage of the application, e.g.:
DIP-Switch S1
(RUN Mode)
5) Power on the board. The user application is started directly.
5.2 Synchronous Mode
In order to program the Flash-ROM synchronously special third-party soft- and hardware has
to be used, e.g. GALEP-4 from www.conitec.de. This tool is not available for free.
A dedicated Flash programming socket (X4) is provided on the evaluation-board for direct
connection to this programmer.
X4: Flash programming socket
© Fujitsu Microelectronics Europe GmbH
SK-96370-144PMC-GDC User Guide
Chapter 5 Programming the internal Flash memory
MD0 MD1 MD2 nc
1
2
Figure 5-1: Flash Programming Socket
- 31 -
ON
OFF
3
4
n/c 1
2 n/c
MD0 3
4 n/c
RST 5
6 SIN3
SOT3 7
8 SCK3
VCC 9
10 GND
FMEMCU-UG-960014-10
Advertisement
Table of Contents
