Storage - MULTIQUIP QP3TZ Operation And Parts Manual

PUMP STORAGE
For storage of the pump for over 30 days, the following is
required:
„ Drain the fuel tank completely.
„ Run the engine for about 3 minutes and then stop.
„ Stop the engine. Drain the engine crankcase oil while the
engine is still warm. Fill engine crankcase with fresh oil.
„ Pull the recoil starter grip (Figure 13) 2 or 3 times. DO
NOT start the engine.
Figure 13. Recoil Starter Grip
„ Pull the recoil starter grip slowly. STOP when it feels tight.
This closes the intake and exhaust valves (compression
position), and helps prevents rust from forming.
„ Wipe any oil or dirt that may have accumulated on the
engine.
QP3TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #4 (05/15/14) — PAGE 23
„ Remove the drain plug from the pump and drain out any
water left in the housing.
„ Remove the pump cover and clean the inside of pump
housing. Coat the inside of pump housing with a light
film of oil to reduce corrosion. A spray can of oil works
well for this application.
„ Cover suction and discharge ports with duct tape to
prevent any foreign matter from falling into pump.
„ Cover pump and engine with plastic covering or
equivalent and store in a clean, dry place.
„ To protect the water cooled-seals, place one-half pint
of lubricating oil (new or used) through the discharge
opening on the pump and crank the engine several times.
This will prevent excessive corrosion and also keep the
mechanical seal lubricated.

STORAGE