Page 1
OPERATION AND PARTS MANUAL MODEL QP4TZ TRASH PUMP (HATZ 1B40U-2230F DIESEL ENGINE) Revision #3 (08/14/14) THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
Page 2
@ www.discount-equipment.com Select an option below to find your Equipment We sell worldwide for the brands: Genie, Terex, JLG, MultiQuip, Mikasa, Essick, Whiteman, Mayco, Toro Stone, Diamond Products, Generac Magnum, Airman, Haulotte, Barreto, Power Blanket, Nifty Lift, Atlas Copco, Chicago Pneumatic, Allmand, Miller Curber, Skyjack, Lull,...
Engine Service Parts ........32-33 Terms And Conditions Of Sale — Parts ....34 NOTICE Specifications and part numbers are subject to change without notice. PAGE 4 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
COULD result in DEATH or SERIOUS INJURY. CAUTION Indicates a hazardous situation which, if not avoided, COULD result in MINOR or MODERATE INJURY. NOTICE Addresses practices not related to personal injury. PAGE 6 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
Page 6
Also, know the phone numbers of the nearest ambulance, doctor and fi re department. This information will be invaluable in the case of an emergency. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 7...
Page 7
Allow these parts to cool comes into contact with hot engine parts or sparks from before servicing equipment. the ignition system. PAGE 8 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
Page 8
DO NOT lift machine to unnecessary heights. seek medical attention. ALWAYS tie down equipment during transport by securing the equipment with rope. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 9...
Page 9
Recyclers and manufacturers alike promote the process of recycling metal. Using a metal recycling center promotes energy cost savings. PAGE 10 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
A small suction leak in the hose or fittings could prevent the pump from priming. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 13...
PUMP COMPONENTS Figure 3 shows a typical application using the QP4TZ centrifugal pump. Please note that this pump is intended for the removal of clean water. NOTE: CONTACT YOUR NEAREST MULTIQUIP DEALER FOR QUICK DISCONNECT HOSES AND FITTINGS. Figure 3. QP4TZ Pump Application 1.
NEVER operate the engine 5. Dipstick — Remove dipstick to determine if the engine with the muffler removed. oil level is low. If low, add oil as specified. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 15...
3. When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel immediately! PAGE 16 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
NEVER operate the pump without water in the casing as this will cause damage to the mechanical seal. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 17...
3. Pull the starter grip again, hard and fast, pulling it all the way out to start engine. 4. If the engine does not start, repeat steps 2 and 3. PAGE 18 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
This prevents backflow and allows for faster priming when the engine is restarted. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 19...
Refer to the HATZ shop Manual for service procedures. 3. For commercial use, log hours of operation to determine proper maintenance intervals. NOTICE Refer to manufacturer engine manual for specific servicing instructions. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 21...
Page 21
Table 5. Engine oil capacity is 1.16 quarts (1.1 liters). DO NOT over fill. 4. Install drain bolt with sealing washer and tighten securely Figure 12. Engine Air Cleaner Figure 11. Engine Oil (Draining) PAGE 22 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
This closes the intake and exhaust valves (compression position), and helps prevents rust from forming. Wipe any oil or dirt that may have accumulated on the engine. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 23...
Impeller does not turn, pump is hard to start. Adjust clearance by removing shim from behind Impeller and volute binding? impeller. Defective engine? See Engine Owner's Manual. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 25...
“Remarks” Column. assembly/kit that can be purchased, or is not available for sale through Multiquip. PAGE 26 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
3....01542702 ...... OIL SUCTION FILTER ASSY NOTICE Part numbers on this Suggested Spare Parts list may supersede/replace the part numbers shown in the following parts lists. QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 27...
PUMP ASSEMBLY PAGE 28 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
Page 28
CAP SCREW (SUCTION COVER), M12 X 25 0131190820 CAP SCREW (WEAR PLATE), M8 X 20 0131151230 CAP SCREW (CASING), M12 X 30 0105051040 BOLT (PUMP), M10 X 40 QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 29...
Page 29
PUMP ASSEMBLY PAGE 30 — QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14)
Page 30
0105051225 BOLT, BATTERY TRAY ..........2....S/N 4TZ-0419 AND ABOVE 0451250120 SPRING WASHER, BATTERY TRAY .....2....S/N 4TZ-0419 AND ABOVE 0205450120 NUT, BATTERY TRAY ..........2....S/N 4TZ-0419 AND ABOVE QP4TZ TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #3 (08/14/14) — PAGE 31...
Need help?
Do you have a question about the QP4TZ and is the answer not in the manual?
Questions and answers