Exmark Lazer Z Operator's Manual page 44

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.2.3
5.2.4
i) Adjust the two (2) rear upper chain attachment bolts in the slots to take the
slack out of the chains. (Deck is still supported by wood blocks under the
caster roller brackets). Tighten hardware on the rear chains.
j) Adjust the two (2) front upper chain attachment bolts in the slots to take the
slack out of the chains. (Deck is still supported by one wood block under
one of the front roller brackets) If the bolts are all the way to the end of the
slots, shorten or lengthen the rod/swivel assemblies as required, adjust
each side the same amount.
k) Recheck that the 3/4" blocks fit just snugly under the brackets and that the
tension on all the chains are approximately equal. Make sure all chain
attachment bolts are tight. Reposition anti-scalp rollers and tighten securely.
SPRING COMPRESSION ADJUSTMENT
l) Raise deck lift lever to the 5" cutting height position See Fig 9. Adjust spring
compression until proper distance is obtained between the two large washers
(See Fig 11). Adjustment is made by turning the nut at the front of each
spring (clockwise will shorten the spring, counter-clockwise will lengthen the
spring). Lock in position with jam nuts.
NOTE: When above adjustments have been made, the front of the
deck will be slightly lower than the rear of the deck.
Pump Drive Belt Tension.
Self-tensioning - No adjustment necessary.
Mule Drive Belt Tension Adjustment.
Self-tensioning idler, adjust as follows:
a) Stop engine and remove key.
b) Check to make sure the center of the bolt head in the center of the spring
loaded pulley, on left side engine deck support, is positioned between the
centers of the two alignment holes in the left support plate (See Fig 12). It is
necessary to adjust the belt tension when the center of the bolt head is at or
below the center of the bottom alignment hole.
c) When adjustment is necessary, loosen the idler pulley on the right-hand
side so it can move up and down in the slot.
Place a wrench on the 3/8" nut in the center of the spring loaded pulley and
apply upward pressure to relieve tension on the spring (a 1/2" drive breaker
bar and 9/16 socket works best).
Reposition the adjusting pulley to the bottom of the slot.
NOTE: When installing a new belt, it is necessary to reposition the right
adjusting pulley upward in the slot in order to position the center of the
spring loaded pulley between the alignment holes.
www.mymowerparts.com
FIG. 11
SWIVEL ADJUSTMENT
- 39 -